Video i korisnički priručnik

1.3. Snimanje s senzorom

Several methods are available for making a clean ECG recording with BioCoherence. You can start from the home page by initiating a new recording and clicking on "record". Another option is to start from the "progress" page or by clicking on the battery icon at the top of the screen. These actions will automatically connect the application to the Bluetooth sensor and start recording.

During recording, an animation is displayed to illustrate the expected results. However, this animation is not updated in real time with the measurements. The data will be calculated at the end of the recording. The animation helps you to spend the time needed to obtain a good recording, ideally at least two minutes.

Three sliders at the top of the screen, labelled "energy", "activity" and "link", fill up progressively. These cursors must be completely filled to ensure that the information collected is sufficient to calculate all the necessary variables. Once these cursors reach 100%, the recording is considered sufficient.

To ensure recording quality, place a thumb on each sensor. If the signal is not of good quality, use electrode gel or moisten your fingers slightly. Signal quality is evaluated automatically. For example, if you remove a finger, recording stops immediately. If you put your finger back in, reconnection takes about a second, but you may need to recalibrate.

If you don't apply sufficient pressure, move or make sudden movements, the screen changes to a red background, indicating that the data is not being taken into account. The device will wait for recalibration, indicated by the return of the green dots and the absence of the red background, before resuming the recording of good quality data.

Once the cursors are 100% full, click on "Stop". The application will then calculate all the data, and you will be able to consult the various main chapters of the scan recording.